Experimental dump to CDROMs =========================== Starting with dump/restore version 0.4b24 or later versions of dump/restore you can dump to CDROMs. You need a (successfully installed) CD-writing software like cdrecord (tested with versions 1.11a04 onwards) These scripts use the new switch ('V') to restore which signals a multi-volume (non-tape) medium like CDROMs I have used the shell scripts below to generate/verify the dump YOU MUST MODIFY these - especially - adapt FS to the filesystem to be dumped - UserExit to the path to the user exit function like UserInfo below - FiFo to the path to a named pipe (better not on the same filesystem) - your cd device(s) ( I have /dev/cdrom a symlink to /dev/sr0 and /dev/cdrw a symlink to /dev/sr1 ) - your path to cdrecord and - - cdrecord's dev parameter must be adapted to your CD burner - - cdrecord's fs (= input fifo size), use less than 64m if you are short of memory - - cdrecord's speed parameter : this parameter not only depends on the capabilities of your CD burner BUT also on the speed of your CPU !!! With the dump -z6 compression on a 900 MHz Pentium III I had no problems with speed=4 which is the maximum speed for my burner. It looks as if at least speed=6 would be possible on a 900 MHz Pentium III. If speed is to large, cdrecord's input fifo gets empty (as shown by cdrecord) and then you have a buffer underrun. - replace the wayplay command with something which alerts you if you have to change CDROMS - for restore or verification replace /dev/cdrom by something which applies for you (device for the CDreader) DON'T FORGET to generate a boot-CD which has the 0.4b24 restore or a newer version of restore on board I prefer timos_Rescue_Cd_Set-0.6.1 see http://rescuecd.sourceforge.net Please Cc bug-reports to jarausch@igpm.rwth-aachen.de ----------------------------------------------------------------- This file and the scripts were slightly edited when the Helmut Jarausch patch was integrated in dump-0.4b24. Stelian.