do this early, before doing any other
processing on it). */
switch ((*p)->howto->type) {
-#ifdef R_V850_9_PCREL
case R_V850_9_PCREL:
-#endif
-#ifdef R_V850_22_PCREL
case R_V850_22_PCREL:
-#endif
-#ifdef R_V850_SDA_16_16_OFFSET
case R_V850_SDA_16_16_OFFSET:
-#endif
-#ifdef R_V850_SDA_15_16_OFFSET
case R_V850_SDA_15_16_OFFSET:
-#endif
-#ifdef R_V850_ZDA_15_16_OFFSET
case R_V850_ZDA_15_16_OFFSET:
-#endif
-#ifdef R_V850_TDA_6_8_OFFSET
case R_V850_TDA_6_8_OFFSET:
-#endif
-#ifdef R_V850_TDA_7_8_OFFSET
case R_V850_TDA_7_8_OFFSET:
-#endif
-#ifdef R_V850_TDA_7_7_OFFSET
case R_V850_TDA_7_7_OFFSET:
-#endif
-#ifdef R_V850_TDA_16_16_OFFSET
case R_V850_TDA_16_16_OFFSET:
-#endif
-#ifdef R_V850_TDA_4_5_OFFSET
case R_V850_TDA_4_5_OFFSET:
-#endif
-#ifdef R_V850_TDA_4_4_OFFSET
case R_V850_TDA_4_4_OFFSET:
-#endif
-#ifdef R_V850_SDA_16_16_SPLIT_OFFSET
case R_V850_SDA_16_16_SPLIT_OFFSET:
-#endif
-#ifdef R_V850_CALLT_6_7_OFFSET
case R_V850_CALLT_6_7_OFFSET:
-#endif
-#ifdef R_V850_CALLT_16_16_OFFSET
case R_V850_CALLT_16_16_OFFSET:
-#endif
/* These are relative relocations, which
have already been fixed up by the
linker at this point, so just ignore
#endif
#ifdef TARGET_v850
-# ifdef R_V850_32
- case R_V850_32:
-# else
case R_V850_ABS32:
-# endif
relocation_needed = 1;
sym_vma = bfd_section_vma(abs_bfd, sym_section);
sym_addr += sym_vma + q->addend;
break;
-#if defined(R_V850_ZDA_16_16_OFFSET) || defined(R_V850_ZDA_16_16_SPLIT_OFFSET)
-#ifdef R_V850_ZDA_16_16_OFFSET
case R_V850_ZDA_16_16_OFFSET:
-#endif
-#ifdef R_V850_ZDA_16_16_SPLIT_OFFSET
case R_V850_ZDA_16_16_SPLIT_OFFSET:
-#endif
/* Can't support zero-relocations. */
- printf ("ERROR: %s+0x%x: zero relocations not supported\n",
+ printf ("ERROR: %s+0x%"BFD_VMA_FMT"x: zero relocations not supported\n",
sym_name, q->addend);
continue;
-#endif /* R_V850_ZDA_16_16_OFFSET || R_V850_ZDA_16_16_SPLIT_OFFSET */
#endif /* TARGET_v850 */
#ifdef TARGET_h8300